About this item

Compatible models: 9.1-inch screen protector, compatible with ANYCUBIC Photon Mono X 6Ks LCD resin 3D printer.

Light transmittance: The light transmittance of the tempered film is greater than 95%, which will not affect the light emitted by the monochrome screen to pass through the tempered film to cure the resin in the resin tank.

Protection: The tempered film has a good protective effect. It not only protects the monochrome screen from being scratched by sharp objects in daily use, but also prevents the release film from being damaged and causing resin leakage to contaminate the screen.

Easy to install: Easy to use, there is a protective film on the back of the tempered film. Please keep the screen clean before use, then tear off the protective film on the back and install the tempered film on the monochrome screen. Use a plastic scraper to avoid bubbles. After installation, please wipe the tempered film clean with cleaning fluid and non-woven cloth. (Only equipped with a scraper)

Tip: To avoid printing problems, it is recommended to level the 3D printer again after installing the tempered film.

Light transmittance

The light transmittance of the tempered film is greater than 95%, which will not affect the light emitted by the monochrome screen to pass through the tempered film to cure the resin in the resin tank.

Add replaceable protective film

The resin liquid leaks directly, and the screen protective film effectively prevents damage to the LCD screen.

Keep Your Screen Safe From Resin Spills

*Prevent resin leakage from contaminating thescreen due to damage to the release film.

*Simply replace the screen protector

*You will have a protective and high-transmittancescreen

Package Includes

1*Plastic Scraper

5*Screen Protector

Installation Of LCD Screen Protector Step

Step 1.Tear Off the stained screen protector and clean the curing screen with tool kit.

Step 2. Peel off the backing of the screen protector. Align the protectorwith edge of screen and stick it from one end to the other with plastic scraper.Get the installation carefully with out air bubbles.

Step 3. Use plastic scraper to remove remaining bubbles by pushing each bubble to the edge of screen slightly. Smooth down the screen protector and peel off the front cover to finish