Product usage instructionsand precautions

(1)Before use:

Shake the liquid resin before use,Clean the resin tank and the molding platformto keep the bottom of the resin tank in lighttransmission.

(2)When using:

Unscrew the cap and add it to the resin tankaccording to the equipment requirements, Selectthe correct print parameters and settings forprinting.

(3)After use:

After printing, please use the matching tools forpost-processing,including blade,diagonal pliers.tweezers, containers, gloves; clean with water.

(4)Post-processing steps:

A. Remove the printed model from the moldingplatform with a blade;
B.Submerge the model in the cleaning solution,rinsed or ultrasonically washed, then taken outand drained;Anycubic Wash and Cure machinesare suggested to ensure better effect.

1.The ideal condition for storing uncured resin isa cool,dark place at room temperature and protectfrom light to avoid high temperature or sunlight.

2.Suggested operating temperature is 18-35C,anda low temperature may affect the printingeffect,thus,the resin can be properly preheatedbefore use (not more than 60C).

3.lf the resin pigment settles, it can be used afterstirringor shaking.

4.In order to ensure the performance oftheresin,please take out the model in time aftercleaning to avoid the model soakingin water for along time.

5.To ensure the mechanical properties of themodel,please perform post curingin time aftercleaning and drying

6.To ensure the mechanical properties ofthe model,please perform post curingin timeafter cleaning and drying. To ensure the idealperformance of the curable material,it is necessaryto control the intensity and time ofthe light sourceafter curing.Therefore, the following steps are

recommended:
(1)The intensityofmercury lamp or LED light sourceis 5-10mw/m2,and the duration is no more than 1hour(self-regulation);
(2)The exposure timein the sun (summer)is around l hour;
(3)Proximity orlong-term exposure under stronglightsources such as high-power high-pressure mercurylampsis prohibited.
(4)lt is recommended to print in a dark room or be coveredwith a lid while printing as resin is a photosensitive material.
S:Material properties will vary depending on the molding
equipment, post-curing method and testingequipment.For safetyinformation, please refer to the MSDSof this product.lf you encounter any problems while using,please feel free to contact us.