Product Description
Wash, Dry, and Cure Your Large Prints!
Whether you are new to resin 3D printing or have been here for a while, you must have known the agony of cleaning and curing your prints.
Well, we are going to change that!
Introducing the Phrozen Wash & Cure Kit!
Wash 10” Building Plates With Ease
* Clean Delicately With Powerful Vortex
* Dunk Your Mighty 8K’s Plate Straight In!
Dry & Cure All in One Go!
* Dry models faster with the Dual Fan System
* No More Sticky and Unevenly Cured Models
Instructions for use
* The ambient temperature for best use is 0-40 ° C and the humidity is 20% -50%.
* The model is better after cleaning, air drying and then curing.
* If the machine will not be used for a long time, pls disconnect the power supply to extend the service life.
* After cleaning, remove the cleaning bucket and close the lid to prevent cleaning solution from getting onto the machine and
causing short circuits
Tips:
STEP 1: WASH
Put your uncured model into the 8L washing station.
STEP 2: DRY
Transfer it to the curing station and start the air drying mode.
STEP 3: CURE
Keep the model inside and turn on the curing mode.
STEP 4: COMPLETED
Take out your awesome model then all done!
Avaliações
Ainda não existem avaliações.